Cast Steel/Stainless Steel Free Ball Float Steam Trap (Thread)
Product Description
Continues discharging saturation condensed water without accumulation, and so get the maximum thermal efficiency.
When steam pressure changes, the ball float can adjust the opening of valve seat without influence, and so it is stable.
With automatic and manual releaser, and so its exhaust performance is good without airlock and working is smooth without noise.
Â
Application:Â
By automation, speediness and continuing features, this valve is used for the steam heating equipment, condensation water recovery system and the place where needs removing condensation water at quick speed, and so stop steam leakage effectively and obtain optimum heating.
Working Principle:Â
By the action of buoyancy, the position of floating ball changes with the water level of condensation water and adjust the opening of valve seat automatically, continue to discharge condensation water, when the condensation water stops, the floating ball fall onto bottom by gravity, then close opening of drain valve. The opening of drain valve is below the water lever, and so the water is separated from steam automatically, and form water seal without steam leakage.
Â
| Main Part | Materal |
| Body | Carbon Steel |
| Bonnet | Carbon Steel |
| Seat | Stainless Steel |
| Percolator | Stainless Steel |
Main Basis for Type Selection:Â
Condensation water loading (discharge)kg/h (select the multiplying power 2~3 times).
Maximum working pressure Mpa
Operation pressure differential
Valve material and nominal pressure
Connection mode and dimension
Â
Use and Maintenance:Â
Confirm the valve material, pressure and check if the maximum is suitable for operation condition.
Before installation, clean the pipeline and clear away sundries.
The installation position shall be closed to heating equipment as much as possible.
Install the minimum point of pipe horizontally and the direction of flow should be the same to the label of valve.
Install steam trap for each heating equipment in case cause influence each other.
under the safe operation of system, open the valve in front of the steam trap, make it rise up to normal station slowly.
Do time-based maintenance for the normal working of steam trap.
Â
Â
there will be about 35% carbon black residual from tyre pyrolysis machines
it could be sold directly or refined into better quality ones.
say N330 or N660
it could be widely used for additives
say rubbers for playground, for car tyres, or shoes etc.
usually there are models with capacities from 1-20tons per hour
Working Principle
The grinding Process of the Main Mill is that the transmission device brings along the Central Shaft to drive. The upper part of the shaft connects with the Quincunx Rack, on the frame is loaded with the roller assembly, and forms a swinging pivot. The central shaft does revolve around the central rotation, at the same time it revolves around the grinding rings, and it self also rotates on account of the grinding effect. The shovel system, in the lower part of rollers, is loaded on the lower part of the Quincunx Rack. In the process of rotating of the shovel and the roller, the material will be fed gasket layer between the rollers and ring. The outside centrifugal force (compression force) yielding in this process will process the material into small powder, thus the desired powder is obtained.
Carbon Black Recycling Machine
Carbon Black Recycling Machine,Continuous Black Oil Recycling Machine,Oil Recycling Machine,Waste Oil Recycling Machine
Henan Lanning Technology Co., Ltd , http://www.lanningrecycling.com