Powder material car engine file details
Drivers' friends do not know the performance and function of the car after purchasing the powdered material transporter. The following powdered material transport vehicle manufacturers will introduce the use of the car to the driver's friends to share: The purchase of ordinary powder materials transport When a car user just touches the Shaanxi Auto-Steyr vehicle equipped with a Fuller gearbox, it often reflects that the transporter of the powdered material has started to go out of order. This is often a place where the operation of the Fuller gearbox is not understood without the use of explanations or understanding, or through training. There is no synchronizer in the main transmission of the Fuller gearbox, since this start-up gear is required to use a splitter brake. If only the separator pedal is stepped on and the splitter brake switch valve is not opened, then the brake will fail and the catch will be difficult. A user knows to start operating as required, but it still reflects bad gear. In general, the driver is too low, the legs are too short, and the seat is too high. When you start walking, the legs are straight and you are not in the position of the brake. At this point, you should adjust the height of the chair to meet the requirements.
If you say that the separator pedal has already opened the brake switch valve and it is difficult to hang the start of the block, then explain that the brake system of the separator is faulty. At this time, you should first check the angry road and turn the brake valve to the Fuller gearbox. The lower left joint is released and the separator pedal is pressed down to the position where the splitter opens the brake valve. Check the trachea joint carefully. If the scavenging is not smooth, explain that the failure of the brake switch valve should be dismantled or changed; if the exhaust gas is unobstructed, the separator must be dismantled to make the cylinder, and carefully check whether the closed tight ring of the air cylinder is worn out and the piston is moving freely. There is no card issue; if an air leak occurs, the “O†ring needs to be changed. Finally, check whether the concave surface of the piston braking arc is worn badly. If the wear is serious, replace the brake piston of the concrete mixer truck.
If it is found that the gear is difficult to shift when the vehicle is normally walking, then it should first check whether it is a malfunction of the remote gear lever. If the gear lever is improperly adjusted or even leaked, it will cause increased gear resistance and difficult gear failure. In particular, some gears are difficult to assemble. They can be used to adjust the upper gear block arm support adjustment screw on the transmission so that the steering column is in an appropriate position.
The above is the material transportation vehicle manufacturer (sales manager: Chen 187 2798 1199). It describes the problems encountered during the normal operation of the powder material transport vehicle. I hope that the driver's friends will continue to pay attention to our powder material transport vehicle. More About the function and description of the powdered material transporter.
Greenstar Series-Commercial Heat Pump
Greenstar Series commercial heat pump water heater is high efficiency, energy saving, environment friendly, water heating solution. It is a combination of the highest quality and last eco-friendly technology.
commercial heat pump water heater,comercial heat pump,comercial hot water heat pump
Guangdong New Energy Technology Development Co., Ltd. , https://www.newenergy-e.com