Air compressor installation precautions

1. When the air compressor is installed, it is necessary to have a wide and well-lit place for operation and maintenance.

2. For those who have access to the roads and conditions, they may install a crane to facilitate the maintenance of the air compressor equipment.

3. Reserve space for maintenance. There must be at least 70 cm distance between the air compressor and the wall.

4. The relative humidity of the air should be low, dust is small, the air is clean and well ventilated, away from flammable and explosive, corrosive chemicals and harmful unsafe items, avoid places close to the distribution of dust.

5. When the air compressor is installed, the ambient temperature in the installation site should be higher than 5 degrees in winter and less than 40 degrees in summer because the higher the ambient temperature, the higher the air compressor discharge temperature, which will affect the performance of the compressor. When installing, ventilating or cooling devices should be installed.

6. The air compressor is at least one meter away from the top space.

7. If the factory environment is poor and there is a lot of dust, install pre-filter equipment.

8. Air compressor installations should be arranged in a single row within the air compressor unit.

Sand Casting, also known as sand molded casting, is a metal casting process characterized by using sand as Sand casting, The term "sand casting" can also refer to an object produced via the sand casting process. Sand castings are produced in specialized factories called foundries. Over 70% of all metal castings are produced via a sand casting process.

Sand casting is relatively cheap and sufficiently refractory even for steel foundry use. In addition to the sand, a suitable bonding agent (usually clay) is mixed or occurs with the sand. The mixture is moistened, typically with water, but sometimes with other substances, to develop strength and plasticity of the clay and to make the aggregate suitable for molding. The sand is typically contained in a system of frames or mold boxes known as a flask. The mold cavities and gate system are created by compacting the sand around models, or patterns, or carved directly into the sand.

Basic process

 There are six steps in this process:

 1.Place a pattern in sand to create a mold.

 2.Incorporate the pattern and sand in a gating system.

 3.Remove the pattern.

 4.Fill the mold cavity with molten metal.

 5.Allow the metal to cool.

 6.Break away the sand mold and remove the casting.

Sand Casting

Gray Iron Castings,Ductile Iron Sand Castings,Customized Sand Castings,Precision Silica Sand Casting

A&M Manufacturing Co.Ltd. , https://www.am-casting.com